SVT Lightning, Built motor + Trans 500 HP in West Sacramento, California For Sale
Type: Cars, For Sale - Private.
Kills me to do this... but I'm in a hard place right now, and life is changing - hopefully for the better.
xxxx SVT LIGHTNING, # xxxx,
55,900 Miles
JLP short block build/labor
Ported Eaton
Ported Heads
JLP stage 2 cam
Accufab Single Blade TB
JLP intake and filter
60 lb injectors
Dual Walbros
Dynatech Long Tubes
Bassani Exhaust
Cobra Water Pump
8 Lb Pulley
AFCO heat exchanger
Electric fan - manual switch near the battery
Drive Shaft Loop
JLP Long Bar Mounts (bars have been removed)
Eibach lowering Kit
Powder Coated Wheels
Nitro Differential Cover
Brake Performance black coated Drilled/Slotted rotors/semi metallic pads (less than 5K street miles on them)
Amazon Tuning Thunderbolt Built Trans
B&M Deep Finned Pan + Amsoil Fluid
PLX AFR gauge with XCAL data log link
Truxedo Lo Pro Tonneau
Cervinis Wing
Black housing headlights+corners
Black Depot Tails
Complete cab off professional respray of factory Bright Red. Paint is hardcore polished and waxed, and looks absolutely amazing, save for the curb rash on the BOTTOM side of the front bumper.
I'm located in Sacramento / Travis AFB
Truck is registered in Texas. Not likely to pass Cali smog (lol) but if you're local, there may be a work around???
When I returned from Afghanistan this past November, I pulled the blower and changed the oil (gm supercharger oil), cleaned the intercooler and replaced the elbow, sent the injectors to stieg for a complete rebuild and balance, and installed the oversized idler pulleys from LFP, as well as changed the plugs and oil. Approximately 800 miles on the truck since then. Nitto Drag Radials have about 4K on them, wear bars are close. If the truck doesnt sell quickly I will replace the tires.
I have all the original receipts from the JLP build, and the JLP dyno that put down 500/595. Currently runs a 91 tune from JJ @ WMS and put down 470/552.
When I bought the truck I had it shipped to me, so I'm familiar with the process and can definitely assist with the logistics...